Differences between revisions 1 and 44 (spanning 43 versions)

Electronics

DC Power Supply

Bipolar 24 Volt power supply
- 24V power supplier / selection report
Connector and cable
- Cables for DC24V selection report
+15V regulator (ultra low noise)
Others
- QPD vias voltage (In TAMA case, 180V)
- Coil driver (LIGO High-Voltage type: >140V)
- PZT driver (DC >100V or AC power supply)

RF electronics

Oscillator
- SG010M3R0GB_test_sheet.pdf
- CLIO related
RF Photo detector
- N. Mio JPCS, 122, (2008) 012014
- H. Grote RSI, 78, (2007), 054704
RF QPD detector
Demodulator
EOM driver

Audio Frequency electronics

As a general rule, differential signal transfer should be applied.
Dsub 9-pin connector and cable
Digital front-end circuits
- Anti-Alias / Anti-Imaging filter
- Differential signal buffer Amp.
- Whitening / De-whitening filter
Coil driver
AF photo detector for DC readout
Optical lever sensor

-  ⇤ ← Revision 1 as of 2010-08-09 18:25:01 → 
  Size: 70
  Editor: DaisukeTatsumi
  Comment:
+   ← Revision 44 as of 2010-11-01 14:01:52 → ⇥
  Size: 1342
  Editor: DaisukeTatsumi
  Comment:
-Deletions are marked like this.
+Additions are marked like this.
 Line 1:
-Cabling Rules
+= Electronics =
 Line 3:
-DC Power Supply
+== DC Power Supply ==
 * '''Bipolar 24 Volt power supply'''
  . 24V power supplier / [[attachment:DC_power_supply.pdf|selection report]]
 * '''Connector and cable'''
  . Cables for DC24V [[attachment:DC_power_plan.pdf|selection report]]
 * '''[[attachment:low_noise_regulator.pdf|+15V regulator (ultra low noise)]]'''
 * '''Others'''
  . QPD vias voltage (In TAMA case, 180V)
  . Coil driver (LIGO High-Voltage type: >140V)
  . PZT driver (DC >100V or AC power supply)
-Line 5:
+Line 14:
-RF electronics
+== RF electronics ==
 * '''Oscillator'''
  . [[attachment:SG010M3R0GB_test_sheet.pdf]]
  . [[CLIO/Technicals/OSCdata|CLIO related]]
 * '''RF Photo detector'''
  . N. Mio [[http://iopscience.iop.org/1742-6596/122/1/012014|JPCS, 122, (2008) 012014]]
  . H. Grote [[http://rsi.aip.org/resource/1/rsinak/v78/i5/p054704_s1|RSI, 78, (2007), 054704]]
 * '''RF QPD detector'''
 * '''Demodulator'''
 * '''EOM driver'''
-Line 7:
+Line 25:
-AF electronics
+== Audio Frequency electronics ==
 . As a general rule, differential signal transfer should be applied.
 . Dsub 9-pin connector and cable

 * '''[[CLIO/Tasks/DigitalControl|Digital front-end circuits]]'''
  * Anti-Alias / Anti-Imaging filter
  * Differential signal buffer Amp.
  * Whitening / De-whitening filter

 * '''Coil driver'''
 * '''AF photo detector for DC readout'''
 * '''Optical lever sensor'''