Differences between revisions 14 and 33 (spanning 19 versions)
Revision 14 as of 2010-08-10 22:36:06
Size: 627
Comment:
Revision 33 as of 2010-10-31 21:28:56
Size: 963
Comment:
Deletions are marked like this. Additions are marked like this.
Line 2: Line 2:
== Cabling Rules ==
Line 5: Line 4:
 . Bipolar 24 Volt power supply
 . Connector and cable
 * '''Bipolar 24 Volt power supply'''
  . 24V power supplier / [[attachment:DC_power_supply.pdf|selection report]]
 * '''Connector and cable'''
 * '''[[attachment:low_noise_regulator.pdf|+15V regulator (ultra low noise)]]'''
Line 9: Line 10:
 . Oscillator  * '''Oscillator'''
Line 12: Line 13:
 * '''RF Photo detector'''
  . Grote |RSI 78 054704 (2007)]]
 * '''RF QPD detector'''
 * '''Demodulator'''
 * '''EOM driver'''
Line 14: Line 20:
 . As a general rule, fifferential signal transfer should be applied.
 . Dsub 9-pin connector
 ----
 .
[[CLIO/Tasks/DigitalControl|CLIO Digital front-end circuits]].
 .
Anti-Alias / Anti-Imaging filter
 . Diferential signal buffer Amp.
 .
Whitening / De-whitening filter
 ----
 .
Coil driver
 ----
 .
Optical lever sensor
 .
 . As a general rule, differential signal transfer should be applied.
 . Dsub 9-pin connector and cable

 * '''
[[CLIO/Tasks/DigitalControl|Digital front-end circuits]]'''
  *
Anti-Alias / Anti-Imaging filter
  * Differential signal buffer Amp.
  *
Whitening / De-whitening filter

 * '''
Coil driver'''
 * '''AF photo detector for DC readout'''
 * '''
Optical lever sensor'''

Electronics

DC Power Supply

RF electronics

Audio Frequency electronics

  • As a general rule, differential signal transfer should be applied.
  • Dsub 9-pin connector and cable
  • Digital front-end circuits

    • Anti-Alias / Anti-Imaging filter
    • Differential signal buffer Amp.
    • Whitening / De-whitening filter
  • Coil driver

  • AF photo detector for DC readout

  • Optical lever sensor

LCGT/subgroup/Electronics (last edited 2012-06-06 12:48:41 by OsamuMiyakawa)