Differences between revisions 17 and 23 (spanning 6 versions)

Electronics

DC Power Supply

As a general rule, differential signal transfer should be applied.
Dsub 9-pin connector and cable
Digital front-end circuits
- Anti-Alias / Anti-Imaging filter
- Diferential signal buffer Amp.
- Whitening / De-whitening filter
Coil driver

-  ⇤ ← Revision 17 as of 2010-08-10 22:40:09 → 
  Size: 630
  Editor: DaisukeTatsumi
  Comment:
+   ← Revision 23 as of 2010-08-11 12:03:31 → ⇥
  Size: 698
  Editor: DaisukeTatsumi
  Comment:
-Deletions are marked like this.
+Additions are marked like this.
 Line 2:
-== Cabling Rules ==
 Line 4:
- . Bipolar 24 Volt power supply
 . Connector and cable
+ * '''Bipolar 24 Volt power supply'''
 * '''Connector and cable'''
 Line 8:
- . Oscillator
  . [[attachment:SG010M3R0GB_test_sheet.pdf]]
  . [[CLIO/Technicals/OSCdata|CLIO related]]
+ * '''Oscillator'''
 . [[attachment:SG010M3R0GB_test_sheet.pdf]]
 . [[CLIO/Technicals/OSCdata|CLIO related]]
-Line 14:
+Line 15:
- . Dsub 9-pin connector
+ . Dsub 9-pin connector and cable
-Line 16:
+Line 17:
-----
 . '''[[CLIO/Tasks/DigitalControl|Digital front-end circuits]]'''
  . Anti-Alias / Anti-Imaging filter
  . Diferential signal buffer Amp.
  . Whitening / De-whitening filter
+ * '''[[CLIO/Tasks/DigitalControl|Digital front-end circuits]]'''
  * Anti-Alias / Anti-Imaging filter
  * Diferential signal buffer Amp.
  * Whitening / De-whitening filter
 Line 22:
-----
 . Coil driver
+ * '''Coil driver'''
-Line 25:
+Line 24:
-----
 . Optical lever sensor
 .
+== Sensors ==
 * '''RF Photo detector'''
 * '''RF QPD detector'''
 * '''Optical lever sensor'''