Differences between revisions 17 and 32 (spanning 15 versions)
Revision 17 as of 2010-08-10 22:40:09
Size: 630
Comment:
Revision 32 as of 2010-10-31 20:28:07
Size: 928
Comment:
Deletions are marked like this. Additions are marked like this.
Line 2: Line 2:
== Cabling Rules ==
Line 4: Line 4:
 . Bipolar 24 Volt power supply
 . Connector and cable
 * '''Bipolar 24 Volt power supply'''
  . 24V power supplier / [[attachment:DC_power_supply.pdf|selection report]]
 * '''Connector and cable'''
 * '''[[attachment:low_noise_regulator.pdf|+15V regulator (ultra low noise)]]'''
Line 8: Line 10:
 . Oscillator  * '''Oscillator'''
Line 11: Line 13:
 * '''RF Photo detector'''
 * '''RF QPD detector'''
 * '''Demodulator'''
 * '''EOM driver'''
Line 14: Line 20:
 . Dsub 9-pin connector  . Dsub 9-pin connector and cable
Line 16: Line 22:
----
. '''[[CLIO/Tasks/DigitalControl|Digital front-end circuits]]'''
  . Anti-Alias / Anti-Imaging filter
  . Diferential signal buffer Amp.
  . Whitening / De-whitening filter
 * '''[[CLIO/Tasks/DigitalControl|Digital front-end circuits]]'''
  * Anti-Alias / Anti-Imaging filter
  * Differential signal buffer Amp.
  * Whitening / De-whitening filter
Line 22: Line 27:
----
. Coil driver

----

 . Optical lever sensor
 .
 * '''Coil driver'''
 * '''AF photo detector for DC readout'''
 * '''
Optical lever sensor'''

Electronics

DC Power Supply

RF electronics

Audio Frequency electronics

  • As a general rule, differential signal transfer should be applied.
  • Dsub 9-pin connector and cable
  • Digital front-end circuits

    • Anti-Alias / Anti-Imaging filter
    • Differential signal buffer Amp.
    • Whitening / De-whitening filter
  • Coil driver

  • AF photo detector for DC readout

  • Optical lever sensor

LCGT/subgroup/Electronics (last edited 2012-06-06 12:48:41 by OsamuMiyakawa)