Differences between revisions 19 and 31 (spanning 12 versions)

Electronics

DC Power Supply

As a general rule, differential signal transfer should be applied.
Dsub 9-pin connector and cable
Digital front-end circuits
- Anti-Alias / Anti-Imaging filter
- Differential signal buffer Amp.
- Whitening / De-whitening filter
Coil driver
AF photo detector for DC readout
Optical lever sensor

-  ⇤ ← Revision 19 as of 2010-08-11 08:39:01 → 
  Size: 640
  Editor: DaisukeTatsumi
  Comment:
+   ← Revision 31 as of 2010-10-31 20:23:38 → ⇥
  Size: 898
  Editor: DaisukeTatsumi
  Comment:
-Deletions are marked like this.
+Additions are marked like this.
 Line 2:
-== Cabling Rules ==
 Line 4:
- * Bipolar 24 Volt power supply
 * Connector and cable
+ * '''Bipolar 24 Volt power supply'''
  . 24V power supplier / [[|selection report]]
 * '''Connector and cable'''
 * '''[[attachment:low_noise_regulator.pdf|+15V regulator (ultra low noise)]]'''
-Line 8:
+Line 10:
- * Oscillator
 . [[attachment:SG010M3R0GB_test_sheet.pdf]]
 . [[CLIO/Technicals/OSCdata|CLIO related]]
+ * '''Oscillator'''
  . [[attachment:SG010M3R0GB_test_sheet.pdf]]
  . [[CLIO/Technicals/OSCdata|CLIO related]]
 * '''RF Photo detector'''
 * '''RF QPD detector'''
 * '''Demodulator'''
 * '''EOM driver'''
-Line 17:
+Line 22:
-----
-Line 20:
+Line 24:
-  * Diferential signal buffer Amp.
+  * Differential signal buffer Amp.
-Line 23:
+Line 27:
-----
-Line 25:
+Line 28:
+ * '''AF photo detector for DC readout'''