Differences between revisions 26 and 47 (spanning 21 versions)
Revision 26 as of 2010-08-11 19:10:51
Size: 703
Comment:
Revision 47 as of 2010-11-01 20:13:23
Size: 1459
Comment:
Deletions are marked like this. Additions are marked like this.
Line 5: Line 5:
  . 24V power supplier / [[attachment:DC_power_supply.pdf|selection report]]
Line 6: Line 7:
  . Cables for DC24V [[attachment:DC_power_plan.pdf|selection report]]
 * '''[[attachment:low_noise_regulator.pdf|+15V regulator (ultra low noise)]]'''
 * '''High voltages'''
  . QPD vias voltage (In TAMA case, 180V)
  . Coil driver (LIGO High-Voltage type: >140V)
  . PZT driver (DC >100V or AC power supply)
Line 12: Line 19:
  . N. Mio [[http://iopscience.iop.org/1742-6596/122/1/012014|JPCS, 122, (2008) 012014]]
  . H. Grote [[http://rsi.aip.org/resource/1/rsinak/v78/i5/p054704_s1|RSI, 78, (2007), 054704]]
Line 14: Line 23:
 * '''EOM driver'''
Line 21: Line 31:
  * Diferential signal buffer Amp.   * Differential signal buffer Amp.
Line 25: Line 35:
 * '''AF photo detector for DC readout'''
Line 26: Line 37:

== Safety Control ==
 * '''Mechanical shutter for photo detector protection'''
 * '''Interlock switch'''

Electronics

DC Power Supply

RF electronics

Audio Frequency electronics

  • As a general rule, differential signal transfer should be applied.
  • Dsub 9-pin connector and cable
  • Digital front-end circuits

    • Anti-Alias / Anti-Imaging filter
    • Differential signal buffer Amp.
    • Whitening / De-whitening filter
  • Coil driver

  • AF photo detector for DC readout

  • Optical lever sensor

Safety Control

  • Mechanical shutter for photo detector protection

  • Interlock switch

LCGT/subgroup/Electronics (last edited 2012-06-06 12:48:41 by OsamuMiyakawa)