Differences between revisions 3 and 31 (spanning 28 versions)

Electronics

DC Power Supply

As a general rule, differential signal transfer should be applied.
Dsub 9-pin connector and cable
Digital front-end circuits
- Anti-Alias / Anti-Imaging filter
- Differential signal buffer Amp.
- Whitening / De-whitening filter
Coil driver
AF photo detector for DC readout
Optical lever sensor

-  ⇤ ← Revision 3 as of 2010-08-10 11:18:57 → 
  Size: 123
  Editor: DaisukeTatsumi
  Comment:
+   ← Revision 31 as of 2010-10-31 20:23:38 → ⇥
  Size: 898
  Editor: DaisukeTatsumi
  Comment:
-Deletions are marked like this.
+Additions are marked like this.
 Line 2:
-== Cabling Rules ==
 Line 4:
+ * '''Bipolar 24 Volt power supply'''
  . 24V power supplier / [[|selection report]]
 * '''Connector and cable'''
 * '''[[attachment:low_noise_regulator.pdf|+15V regulator (ultra low noise)]]'''
-Line 5:
+Line 10:
- . Oscillator
 
== AF electronics ==
+ * '''Oscillator'''
  . [[attachment:SG010M3R0GB_test_sheet.pdf]]
  . [[CLIO/Technicals/OSCdata|CLIO related]]
 * '''RF Photo detector'''
 * '''RF QPD detector'''
 * '''Demodulator'''
 * '''EOM driver'''

== Audio Frequency electronics ==
 . As a general rule, differential signal transfer should be applied.
 . Dsub 9-pin connector and cable

 * '''[[CLIO/Tasks/DigitalControl|Digital front-end circuits]]'''
  * Anti-Alias / Anti-Imaging filter
  * Differential signal buffer Amp.
  * Whitening / De-whitening filter

 * '''Coil driver'''
 * '''AF photo detector for DC readout'''
 * '''Optical lever sensor'''