Differences between revisions 31 and 51 (spanning 20 versions)

Analog Electronics

DC Power Supply

Bipolar 24 Volt power supply
- 24V power supplier / selection report
Connector and cable
- Cables for DC24V selection report
+15V regulator (ultra low noise)
High voltages
- QPD vias voltage (In TAMA case, 180V)
- Coil driver (LIGO High-Voltage type: >140V)
- PZT driver (DC >100V or AC power supply)

Oscillator
- SG010M3R0GB_test_sheet.pdf
- CLIO related
RF Photo detector
- N. Mio JPCS, 122, (2008) 012014
- H. Grote RSI, 78, (2007), 054704
RF QPD detector
Demodulator
EOM driver

As a general rule, differential signal transfer should be applied.
Dsub 9-pin connector and cable
Digital front-end circuits
- Anti-Alias / Anti-Imaging filter
- Differential signal buffer Amp.
- Whitening / De-whitening filter
Coil driver
AF photo detector for DC readout
Optical lever sensor
Ultra-Low-Noise Amp.
- NF SA-200F3

-  ⇤ ← Revision 31 as of 2010-10-31 20:23:38 → 
  Size: 898
  Editor: DaisukeTatsumi
  Comment:
+   ← Revision 51 as of 2011-02-09 19:59:06 → ⇥
  Size: 1549
  Editor: ShigenoriMoriwaki
  Comment:
-Deletions are marked like this.
+Additions are marked like this.
 Line 1:
-= Electronics =
+= Analog Electronics =
 Line 5:
-  . 24V power supplier / [[|selection report]]
+  . 24V power supplier / [[attachment:DC_power_supply.pdf|selection report]]
 Line 7:
+  . Cables for DC24V [[attachment:DC_power_plan.pdf|selection report]]
-Line 8:
+Line 9:
+ * '''High voltages'''
  . QPD vias voltage (In TAMA case, 180V)
  . Coil driver (LIGO High-Voltage type: >140V)
  . PZT driver (DC >100V or AC power supply)
-Line 14:
+Line 19:
+  . N. Mio [[http://iopscience.iop.org/1742-6596/122/1/012014|JPCS, 122, (2008) 012014]]
  . H. Grote [[http://rsi.aip.org/resource/1/rsinak/v78/i5/p054704_s1|RSI, 78, (2007), 054704]]
-Line 30:
+Line 37:
+ * '''Ultra-Low-Noise Amp.'''
  . [[attachment:SA200F3_noise.pdf|NF SA-200F3]]

== Safety Control ==
 * '''Mechanical shutter for photo detector protection'''
 * '''Interlock switch'''