Differences between revisions 47 and 56 (spanning 9 versions)

Analog Electronics

Links

Bipolar 24 Volt power supply
- 24V power supplier / selection report
Connector and cable
- Cables for DC24V selection report
+15V regulator (ultra low noise)
High voltages
- QPD vias voltage (In TAMA case, 180V)
- Coil driver (LIGO High-Voltage type: >140V)
- PZT driver (DC >100V or AC power supply)

Oscillator
RF Photo detector
- N. Mio JPCS, 122, (2008) 012014
- H. Grote RSI, 78, (2007), 054704
RF QPD detector
Demodulator
EOM driver

As a general rule, differential signal transfer should be applied.
Dsub 9-pin connector and cable
Digital front-end circuits
- Anti-Alias / Anti-Imaging filter
- Differential signal buffer Amp.
- Whitening / De-whitening filter
Coil driver
AF photo detector for DC readout
Optical lever sensor
Ultra-Low-Noise Amp.
- NF SA-200F3

-  ⇤ ← Revision 47 as of 2010-11-01 20:13:23 → 
  Size: 1459
  Editor: ShigenoriMoriwaki
  Comment:
+   ← Revision 56 as of 2011-09-27 23:39:44 → ⇥
  Size: 1764
  Editor: DaisukeTatsumi
  Comment:
-Deletions are marked like this.
+Additions are marked like this.
 Line 1:
-= Electronics =
+= Analog Electronics =
== Links ==
[[LCGT/subgroup/Electronics/Meetings|Meetings]]
-Line 3:
+Line 5:
+----
-Line 18:
+Line 21:
+  . [[attachment:wenzel_500_13757B.pdf|Wenzel 500 of TAMA]]
    . reference: [[attachment:TAMA_RF_2010.pdf|LO signal distribution for TAMA RSE]]
-Line 38:
+Line 43:
+ * '''Ultra-Low-Noise Amp.'''
  . [[attachment:SA200F3_noise.pdf|NF SA-200F3]]