Differences between revisions 56 and 57

Analog Electronics

Links

Bipolar 24 Volt power supply
- 24V power supplier / selection report
Connector and cable
- Cables for DC24V selection report
+15V regulator (ultra low noise)
High voltages
- QPD vias voltage (In TAMA case, 180V)
- Coil driver (LIGO High-Voltage type: >140V)
- PZT driver (DC >100V or AC power supply)

Oscillator
RF Photo detector
- N. Mio JPCS, 122, (2008) 012014
- H. Grote RSI, 78, (2007), 054704
RF QPD detector
Demodulator
EOM driver

As a general rule, differential signal transfer should be applied.
Dsub 9-pin connector and cable
Digital front-end circuits
- Anti-Alias / Anti-Imaging filter
- Differential signal buffer Amp.
- Whitening / De-whitening filter
Coil driver
AF photo detector for DC readout
Optical lever sensor
Ultra-Low-Noise Amp.
- NF SA-200F3

-  ⇤ ← Revision 56 as of 2011-09-27 23:39:44 → 
  Size: 1764
  Editor: DaisukeTatsumi
  Comment:
+   ← Revision 57 as of 2012-06-06 12:46:03 → ⇥
  Size: 1946
  Editor: OsamuMiyakawa
  Comment:
-Deletions are marked like this.
+Additions are marked like this.
 Line 8:
-  . 24V power supplier / [[attachment:DC_power_supply.pdf|selection report]]
+  . 24V power supplier / [[attachment:LCGT/subgroup/Electronics/DC_power_supply.pdf|selection report]]
 Line 10:
-  . Cables for DC24V [[attachment:DC_power_plan.pdf|selection report]]
 * '''[[attachment:low_noise_regulator.pdf|+15V regulator (ultra low noise)]]'''
+  . Cables for DC24V [[attachment:LCGT/subgroup/Electronics/DC_power_plan.pdf|selection report]]
 * '''[[attachment:LCGT/subgroup/Electronics/low_noise_regulator.pdf|+15V regulator (ultra low noise)]]'''
 Line 19:
-  . [[attachment:SG010M3R0GB_test_sheet.pdf]]
+  . [[attachment:LCGT/subgroup/Electronics/SG010M3R0GB_test_sheet.pdf]]
 Line 21:
-  . [[attachment:wenzel_500_13757B.pdf|Wenzel 500 of TAMA]]
    . reference: [[attachment:TAMA_RF_2010.pdf|LO signal distribution for TAMA RSE]]
+  . [[attachment:LCGT/subgroup/Electronics/wenzel_500_13757B.pdf|Wenzel 500 of TAMA]]
    . reference: [[attachment:LCGT/subgroup/Electronics/TAMA_RF_2010.pdf|LO signal distribution for TAMA RSE]]
 Line 44:
-  . [[attachment:SA200F3_noise.pdf|NF SA-200F3]]
+  . [[attachment:LCGT/subgroup/Electronics/SA200F3_noise.pdf|NF SA-200F3]]