Differences between revisions 3 and 9 (spanning 6 versions)
Revision 3 as of 2012-08-10 22:48:34
Size: 91
Editor: YoichiAso
Comment:
Revision 9 as of 2018-01-18 15:52:23
Size: 981
Editor: YoichiAso
Comment:
Deletions are marked like this. Additions are marked like this.
Line 1: Line 1:
## page was renamed from InstrumentControl/Cryo
Line 2: Line 3:
There are four cold mirrors in KAGRA, two at the center and one each at the end of the 3km tunnels.

Each cold mirror is installed in a cryostat. Each cryostat has 4 cryocoolers. Each cryocooler is powered by a compressor.
Line 3: Line 8:
[[attachment:F70manual-in-english.pdf|Manual]] [[attachment:F70manual-in-english.pdf|Manual]] p54-55

We use the diagnostic interface connector. The pin-out is listed in Table 1 of p54 (p50 at the bottom of the page).

We will use pin #10 and #14 to #20.

There will be four compressors per cryostat. Therefore, the total number of compressors is 16.

== Temperature Sensors ==
We will have 64 temperature sensors per cryostat. There are 4 cryostats. Therefore the total number of the temperature sensors is 256. Each temperature sensor has a differential voltage output. The voltage range is 0-2V for diode sensors (43 sensors out of 64). !PtCo sensors have 0-150mV range (21 sensors out of 64).

Cryo-system control

There are four cold mirrors in KAGRA, two at the center and one each at the end of the 3km tunnels.

Each cold mirror is installed in a cryostat. Each cryostat has 4 cryocoolers. Each cryocooler is powered by a compressor.

Compressor

Manual p54-55

We use the diagnostic interface connector. The pin-out is listed in Table 1 of p54 (p50 at the bottom of the page).

We will use pin #10 and #14 to #20.

There will be four compressors per cryostat. Therefore, the total number of compressors is 16.

Temperature Sensors

We will have 64 temperature sensors per cryostat. There are 4 cryostats. Therefore the total number of the temperature sensors is 256. Each temperature sensor has a differential voltage output. The voltage range is 0-2V for diode sensors (43 sensors out of 64). PtCo sensors have 0-150mV range (21 sensors out of 64).

PLC/Cryo (last edited 2018-01-18 15:52:23 by YoichiAso)