X-end PCal

Urgent

RxPD1 repairing
- Repaired but not tested.
OFS2 closed loop functionality repairing
- Register is missing. To be delivered.
Interlock repairing

2nd-urgent

~10/20 first test to inject PCal laser to the X-end test mass

Rx module alignment
- After vacuuming and ETMX alignment by commissioning team.
AOM response measurement
- Check working point is consistent to that in KEK
OL/CL TF measurement
WSK measurement
- Modification is required from LIGO's procedure.
- Code for WSK measurement analysis
- It is at Toyama Univ.
- May have to prepare voltage calibrator to calibrate readout by DGS.

~X-arm commissioning line injection

~O3

Bonus work

Pre-categorization

Y-end PCal

-  ⇤ ← Revision 17 as of 2018-09-20 16:17:06 → 
  Size: 2537
  Editor: chihiro.kozakai
  Comment:
+   ← Revision 25 as of 2018-10-10 17:46:40 → ⇥
  Size: 2318
  Editor: chihiro.kozakai
  Comment:
-Deletions are marked like this.
+Additions are marked like this.
 Line 20:
- * TxPD1 repairing 
  * Repaired. To be checked.
+ * RxPD1 repairing 
  * Repaired but not tested.
-Line 24:
+Line 23:
-  * Relay is OK. Investigating the cause.
 * DAC noise problem
  * With DAC cable, very large noise and offset are observed. It may be difficult to set working point.
+  * Register is missing. To be delivered.
 * Interlock repairing
-Line 30:
+Line 28:
- * DAC input bias between MEDM and actual
-Line 36:
+Line 33:
-~9/11

 * Periscope install
  * Equip picomoters to the mirror

~10/3
 * Complete periscope install 
 * Rx module alignment
-Line 47:
+Line 35:
+ * Rx module alignment
  * After vacuuming and ETMX alignment by commissioning team.
-Line 53:
+Line 43:
-  * To be delivered on 9/19 or 20 to Toyama Univ.
+  * It is at Toyama Univ.