Check if the real time models are sending data to DAQ
1. Open sitemap on an workstation
$sc $medm sitemap.adl
2. Open CDS screen
3. Open GDS_TP screen of each model (blue buttons)
4. Check that "DC Status" is 0x0
DC status |
What to do |
0x0 |
Good status! |
x4000 |
It is OK. Data is being sent and you can leave it. A master IOP gets this error when the timing synchronization is fucked up. |
x2000 |
It is OK. When the master IOP's timing is not synchronized properly, their slave models show this code. |
0x2 |
The real time model is not sending data to the data concentrator machine, k1dc0. Go to (1) |
blank |
Channels are not registered to send to k1dc0. Go to (2) |
(1)
ssh <FE macehine name such as k1pr0> sudo /etc/init.d/mx_stream restart
mx_stream process will automatically start up again, and the DAC status will be cleared.
(2)
ssh k1dc0 ps -ef | grep daqd
Check the process number of daqd. There may be two or three and pick the first and left number (###).
kill ###
daqd process will automatically start up again, and the DAC status will be cleared. If it did not work, try to reboot the data concentrator:
ssh k1dc0 sudo reboot
Wait patiently until k1dc0 restarts.