IFO Operation Manual

CHECK LIST

• Record K1:PSL-PMC_TRANS_DC_OUTPUT.
  • If it is ~6, OK. If not, ask Miyakawa, Kawamura, or Enomoto to manually lock PMC.
• Record K1:IMC-MCL_TRANS_OUTPUT.
  • If it is ~0.4, OK. If not, check IMC alignment or guardian (see detail below).

• Record IMC oplev values.

   K1:VIS-MCE_TM_OPLEV_PIT_OUTPUT
   K1:VIS-MCE_TM_OPLEV_YAW_OUTPUT
   K1:VIS-MCI_TM_OPLEV_PIT_OUTPUT
   K1:VIS-MCI_TM_OPLEV_YAW_OUTPUT
   K1:VIS-MCO_TM_OPLEV_PIT_OUTPUT
   K1:VIS-MCO_TM_OPLEV_YAW_OUTPUT

General

• Type "mk" on terminal and you will open a "sitemap" screen

PSL

Lock PMC

• Open the "PSL PMC" medm screen from sitemap

• Open StripTool /users/striptool/pmc.stp (link is put on the PMC screen)

• Find PMC_TRANS Camera
• Open the Guardian screen (link on the PMC screen)

• 1. Request "PSL_LOCKED"
• 2. Execute (Choose "EXEC")

• Make sure that PMC is locked with the StripTool, PMC_TRANS camera, and the Guardian. If K1:PSL-PMC_TRANS_DC_OUTPUT ~ 6, PMC is locked. If K1:PSL-PMC_TRANS_DC_OUTPUT ~ 0, unlocked.

IMC

Lock IMC

• Check MCI, MCO and MCE (link to VIS page. DC alignment values, Watchdog, Dackill)
• Open IMC medm from sitemap

• Open StripTools and Guardian from IMC medm

• The usage of the IMC Guardian is almost same as one of PMC. Request "IMC_LOCKED" and execute.
• NOTE: If PMC is unlocked, you will see a message "PSL_is_unlocked!" in USERMSG line in the IMC Guardian. When you see it, check if PMC is locked or not

• Open StripTool /users/stiptool/IMC.stp

• Find MCE_TRANS camera

• Make sure IMC is locked with the StripTool, MCE_TRANS camera, and the Guardian. If K1:IMC-MCL_TRANS_OUTPUT ~ 0.40 - 0.46 , IMC is locked. If K1:IMC-MCL_TRANS_OUTPUT ~ 0.020, unlocked.

Main IFO

Check VIS

• Check PR3, BS, IX and IY (link to VIS page)

Initial Alignment

• http://gwdoc.icrr.u-tokyo.ac.jp/cgi-bin/private/DocDB/ShowDocument?docid=5027

• Make the initial alignment script
• Put the script usage

Lock Michelson IFO

• Establish the lock procedure
• Prepare Guardian and put the manual here

• Prepare StripTool (list of check channels)

Check DAQ

• MonitCheck Check if all the DAQ system is working properly

• DaqCheck1 Check if the real time models are sending data to DAQ

• DaqCheck2 Check if the GW channel is properly recorded in the frames

• Check Detchar screen?
• Check glitch rate (prepare a script?)
• Check noise lines (prepare a script?)

In the case of IFO/subsystem failure or emergency