Differences between revisions 11 and 12
⇤ ← Revision 11 as of 2019-12-08 13:02:13 →
Size: 1215
Editor: miyoki
Comment:
← Revision 12 as of 2019-12-08 13:03:49 → ⇥
Size: 1176
Editor: miyoki
Comment:
Deletions are marked like this. Additions are marked like this.
Line 11: Line 11:
  * You can hear the sound of fun and LED horizontal ilumination in (9). Red shows heating power, while green shows cooling power.
  * Push (5)"SET" for 2 seconds, then you can find the display blinking. The blinking value is the present target temperature.		   * You can hear the sound of fun and see LED horizontal illumination in (9). Red shows heating power, while green shows cooling power.
  * Push (5)"SET" for 2 seconds, then you will see the present target temperature.

There are two precision cooler for PSL room. Normally one of them is operated in the "quiet mode".
Sometimes two are operated for working mode.

  1. Preparation before operation

    • Check the temperature is displayed in the "(1)" in Control Panel . If not call S. Miyoki or H. Hayakawa.

    • Please remember that the air slide type shutter that is situated at the connection point between the box shape cooler body and the air duct should be open when you operate the coolers. The slide shutter can easily slide by hands.

  2. How to operate the Precision Cooler for PSL room

    • Push (3)"RUN/STOP" in Control Panel

    • You can hear the sound of fun and see LED horizontal illumination in (9). Red shows heating power, while green shows cooling power.
    • Push (5)"SET" for 2 seconds, then you will see the present target temperature.
    • Push (6)(7) for change the blinking number. Push (8) to change the order position.
    • If you set your target value, push (5) shortly.
    • That's all

KAGRA/Operation/Manuals/FCL/PSL/PrecisionCoolerControl (last edited 2019-12-10 15:11:35 by miyoki)