PR3 DC alignment (Kokeyama Dec/18/2019)
Make sure VIS_SR3 guardian is ALIGNED. You can check on terminal by "guardctrl status VIS_SR3".
Please put -26 (<- this value is an example) to K1:VIS-SR3_IM_OLSET_P_OFFSET. From terminal, you cando "caput K1:VIS-SR3_IM_OLSET_P_OFFSET -26 (<- this value is an example) "
Make sure K1:VIS-SR3_TM_OPLEV_PIT_DIAGMON goes to -26 (<- this value is an example) . You can check on terminal by "caget K1:VIS-SR3_TM_OPLEV_PIT_DIAGMON"
- Make sure green Y arm transmission goes close to 1. Check by "caget K1:AOS-TMSY_GR_PDA1_OUTPUT"
Then you can start FPMI Locking by pushing "FPMI_LSC_Locking" in LSC_LOCK guardian in LSC_LOCK, or the initial alignment (if it seems necessary)
