746
Comment:
|
745
|
Deletions are marked like this. | Additions are marked like this. |
Line 3: | Line 3: |
* Make sure [[http://k1sum0.kagra.icrr.u-tokyo.ac.jp/~controls/Manual/img/VIS/GRD-VIS_SR3.MAINc.png |VIS_SR3 guardian]] is ALIGNED. You can check on terminal by guardctrl status VIS_SR3 | * Make sure [[http://k1sum0.kagra.icrr.u-tokyo.ac.jp/~controls/Manual/img/VIS/GRD-VIS_SR3.MAIN.png |VIS_SR3 guardian]] is ALIGNED. You can check on terminal by guardctrl status VIS_SR3 |
PR3 DC alignment
Make sure VIS_SR3 guardian is ALIGNED. You can check on terminal by guardctrl status VIS_SR3
Please put -26 (<- this value is an example) to K1:VIS-SR3_IM_OLSET_P_OFFSET. From terminal, you cando caput K1:VIS-SR3_IM_OLSET_P_OFFSET -26 (<- this value is an example)
Make sure K1:VIS-SR3_TM_OPLEV_PIT_DIAGMON goes to -26 (<- this value is an example) . You can check on terminal by caget K1:VIS-SR3_TM_OPLEV_PIT_DIAGMON
- Make sure green Y arm transmission goes close to 1. Check by caget K1:AOS-TMSY_GR_PDA1_OUTPUT
- Then you can start LSC_LOCK guardian, or the initial alignment (if it seems necessary)