PR3 DC alignment
Make sure VIS_SR3 guardian is ALIGNED. You can check on terminal by guardctrl status VIS_SR3
Please put -26 (<- this value is an example) to K1:VIS-SR3_IM_OLSET_P_OFFSET. From terminal, you cando caput K1:VIS-SR3_IM_OLSET_P_OFFSET -26 (<- this value is an example)
Make sure K1:VIS-SR3_TM_OPLEV_PIT_DIAGMON goes to -26 (<- this value is an example) . You can check on terminal by caget K1:VIS-SR3_TM_OPLEV_PIT_DIAGMON
- Make sure green Y arm transmission goes close to 1. Check by caget K1:AOS-TMSY_GR_PDA1_OUTPUT
- Then you can start LSC_LOCK guardian, or the initial alignment (if it seems necessary)
