Differences between revisions 20 and 21
Revision 20 as of 2013-02-15 13:53:00
Size: 3487
Comment:
Revision 21 as of 2013-02-15 13:56:04
Size: 3506
Comment:
Deletions are marked like this. Additions are marked like this.
Line 14: Line 14:
Line 15: Line 16:
<<Anchor(VIS)>>

Analog Electronics

Meeting

2012/11/9 10:00~ How to make a circuit using AEL


Circuits for subsystem


VIS

LVDT driver

  • D1201253 Test Circuit of Voice Coil Driver

  • D1201251 Presentation for MIF meeting

  • D1201255 LVDT-Actuator Driver Electronics

  • JGW-D1201467: LVDT and Voice Coil Drivers Electric Circuits (1/5/2013

2013/2/15 meeting (高橋、宮川、上泉)

  • 何ch必要か -> 100ch -> 基板24枚

    • 8ch単位で一箱 -> 計12箱

  • 基板はニケフから購入することを考える
    • 基板の箱詰めを考える
      • 安定化電源内臓のため、外部から18Vを直結
      • インターフェース -> 要検討

        • 位相ねじにフロントパネルからアクセス(穴をあける)
        • テストピンが必要かどうか確認
  • 変調信号出力を箱の中に内臓
    • 変調周波数は固定(TAMAの回路図参考)
    • 外部から変調周波数を入れるのも作っておく
  • 箱詰めした回路の完成8月完成を目処


DC Power Supply

RF electronics

Audio Frequency electronics

  • As a general rule, differential signal transfer should be applied.
  • Dsub 9-pin connector and cable
  • Digital front-end circuits

    • Anti-Alias / Anti-Imaging filter
    • Differential signal buffer Amp.
    • Whitening / De-whitening filter
  • Coil driver

  • AF photo detector for DC readout

  • Optical lever sensor

  • Ultra-Low-Noise Amp.

Safety Control

  • Mechanical shutter for photo detector protection

  • Interlock switch

KAGRA/Subgroups/AEL (last edited 2020-01-31 14:07:44 by MasahiroKamiizumi)