|
Size: 905
Comment:
|
← Revision 7 as of 2018-09-24 21:54:58 ⇥
Size: 940
Comment:
|
| Deletions are marked like this. | Additions are marked like this. |
| Line 4: | Line 4: |
| * [[http://klog.icrr.u-tokyo.ac.jp/osl/?r=6256]] * [[http://klog.icrr.u-tokyo.ac.jp/osl/?r=6257]] |
|
| Line 7: | Line 9: |
| * Handed over the TMS-VIS, the BRT, and some other parts including geophones to a transportation comapny. | * Shown in the above links. |
| Line 10: | Line 12: |
| * Wait until one day so that the temperature of them will become equilibrium with the environment in the Xend. * Then, somehow connect the cut signal wires of a LVDT. |
* Repairing some damaged parts * Connect the cut signal wires of a LVDT. * Glue the wire part of an actuator coil about to be loosen. * Replace the damages actuator coils. |
20180920
Today's activities
Workers: Akutsu, Uraguchi, Yano at Mitaka
- Shown in the above links.
Next plan
- Repairing some damaged parts
- Connect the cut signal wires of a LVDT.
- Glue the wire part of an actuator coil about to be loosen.
- Replace the damages actuator coils.
- Check the integirty of the coils (LVDTs and actuators) by testers
Clean the sides of the optics to be installed into the vacuum chamber. (Ethanol+Acetone wiping with vectra alpha, then First Contact.) See here.
Wanted!
- Tester!! lend from DGS or PEM??
- First contact to clean the side diameter of the optics.