O4 Commissioning Task List

This is a list of things to do for each commissioning stage for O4.

Each stage include ASC.

References

• klog review during O3 commissioining JGW-E2112729

• Summary of Optical Characterization

• MIF Schedule Estimate for bKAGRA Phase 2 JGW-T1707079

• Definitions for the X arm commissioning JGW-T1808343

• Definitions for the DRMI commissioning JGW-T1909573

Preparations

• Tune f1, f2, f3 frequencies to IMC FSR

• Replace all the in-vac steering mirrors and pick-off mirrors to proper ones JGW-T2112592

• Replace all the beam splitters in in-air optical tables to non-polarizing beam splitters JGW-D2112956

  • This is necessary to estimate the polarization content of the interferometer correctly (without too much confusion)
• Install polarization optics to backward POP or POS, and TRY and TRY.

  • This is necessary to estimate the arm cavity round-trip loss correctly JGW-T2011633

Xarm

• Measure the finesse at room temperature and at cryogenic temperatures, for both 1064 nm and 532 nm.
• Measure the round-trip loss by taking into account the effect of birefringence correctly.
  • Measure the beam spot position dependence
• Measure the mode-matching for both 1064 nm and 532 nm.
• Tune the Gouy phase separation between two QPDs at TRX.
• Measure the alignment sensing matrix at REFL/AS/TRX, for ITMX and ETMX.
  • Try closing ASC loops.
• Measure modulation depths for f1, f2 and f3.

Yarm

• Same as Xarm

Michelson

FPMI

PRFPMI