• KAGRA
• Subgroups
• PEM
• Meeting
• 210820
• Agenda

Weekly PEM meeting

• 2021/08/20(Fri) 17:00-
• Regular meeting

• Zoom2 : https://zoom.us/j/6676627462

Conference issue

• 27th KAGRA Face-to-face meeting

  • 27-29, Aug. Registration, Remote style

  • Registration deadline : August 20 (Fri) 6:00PM JST.
  • If you have a plan to have a presentation or poster, please let me know.
    • PEM status and publication reports (Washimi) : oral
    • Water NN (Suzuki) : poster
    • ICA (Kobayashi) : poster
    • Schumann resonance (Washimi) : poster
    • Seismic motion (Yokozawa) : poster
• LVK meeting

  • url

  • 6,7,8,9,10 September

• JPS meeting url

  • Yuzurihara(ICRR) : 14pW3-5
  • Kobayashi(OCU)
  • Washimi(NAOJ) in "Environmental physics session"

• Other meetings url

• GWPAW Hannover, Germany, Dec 14th-17th, 2021

If you have some presentation about PEM related, please contact to me.

Business travel

• Depending on the situation of COVID-19
• Suzuki (Tokyo) to Kamioka : 8/16-26

General issue

• Interferometer schedule
  • Procedure toward X arm commissioning

    • url

    • Pcal finalize->Oplev finalize->Suspension health check->Acceptance check

  • IO commissioning
    • IMC ASC
    • ALS
  • Initial alignment
    • Set oplev to good alignment point (PR2, PR3, ITMX, ETMX)
  • Mid size baffle installation
• Schedule

  • figure

• PEM schedule
  • Re-installation of PEMs toward O4

Jurnal paper issue

Details are here!

• PTEP (2) : noise budget(K.Yamamoto, Kokeyama, Washimi) Check list, slack <<Writing>>

  • NB plot has been finalised
  • PWT is checking the draft v0

• Reverberation time paper (Washimi+) <<Start writing>>

• ICA for E-run/O3GK (Kume, Yokoyama) <<Analysis ON GOING>>

• Portable PEMs (Yokozawa+) <<Start writing>>

Preparation for O4

• PEM cabling

  • XY-end channel assignment JGWDco13125 and cabling

    • Preparation of both XY end PEM channel was done
  • Channel re-assignment
    • Added new ADC to MCF0 and IY0 rack

    • Summary of PEM channels klog17897

  • Box install for SR/OMC area
    • Done
  • Box install for XY front/end
    • Start project
  • Seis for BS/OMC
    • Is it better to set them to EYC for water analysis?
  • Voltage monitor
  • Booth MIC setting
    • BS, SR done
  • Table PEM setting (After IMC ASC commissioning)
  • Set calibration factor
• New PEM
  • Ondotori
  • Pt 100 by ondotori
  • TEAC710
  • 電界計 (EFM; electric field mill)
  • ACO power supply with low frequency
• Vibration projection
  • Discussion with CAL team about A chamber
  • After Rx PD finalization and before closing chamber
• PEM injection

  • Low-frequency sound injectorklog16829

  • Acoustic injection at X/Y-end
  • Magnetic injection

• After O4
  • RF monitor
  • Tiltmeter
  • RI detector
  • Newtonian noise
• Discussion with DET members
  • Daily summary page PEM

Progress report

• Yuzurihara
  • Interferometer commissioning
  • Pastavi
• Nishizawa
  • Magnetic field analysis
• Hoshino
  • Seismic motion analysis
• Investigation of ICA analysis
  • Progress
• Suzuki
  • Water simulation
• Washimi

  • Weather around Obon : klog17917

  • Lightening sensor : No progress
  • ICA : No progress

  • Water NN : with Suzuki-kun (meeting slide on 8/13 : JGW-T2113190)

• Yokozawa
  • Temperature at PSL room
• Seismic motion analysis
  • O3GK
  • Microseismic
  • Long term

Place for memo