Contents
Acceptance Test
Flow chart
A: Design phase
A01 : Could the simulation satisfy the requirement?
Input
- KAGRA requirements
- Input the design sensitivity (ref. xxx)
- Input the DAC limit (ref. xxx)
- Suspension model
- plant model : rigid body model by SUMCON (ref. xxx)
- control model : LTI model by Matlab simlink (ref. xxx)
- noise model : seismic noise, control noise (ref. xxx)
Content
Output
- Transfer function
- transfer function of the suspension (ref. xxx)
- Noises
- requirement for sensor noises (ref. xxx)
- requirement for actuator noises (ref. xxx)
B: Installation phase
B01 : Tower is installed?
- Cable connection
- Resistance (Ohom)
- Continuity (OK/NO)
- Calibration (LVDT, ACC)
- Calibration (plot, polarity, coefficient)
- Sensor noise (plot)
- Working point and dynamic range with FR, Limit SW
- Range (from -mm to +mm)
- Minimum range (mm)
- Optimal point (mm)
- Limit SW (on/off)
- Tuned frequencies of GAS Filter/IP
- Frequency (TF, actuator efficiency)
- Maximum frequency (Hz)
B02 : Payload is installed?
- Please write
- aaaa
B03 : The whole suspension is working in air?
- Please write
- aaaa
=== B04 : The whole suspension is working in vacuum?===
- Please write
- aaaa
C: Integration phase
C01 :
- Damping time
- RMS in spectrum (plot)
- Healthy check
- Transfer function (plot)
- Resonant frequencies (PreQUA)
- Noise budget
- Spectrum (plot)
- Automation
- check the guardian transition
C02
- Please write
- aaaa