Differences between revisions 1 and 10 (spanning 9 versions)
⇤ ← Revision 1 as of 2020-10-07 09:41:51 →
Size: 2133
Editor: RyutaroTakahashi
Comment:
← Revision 10 as of 2020-10-09 13:49:56 → ⇥
Size: 3196
Editor: terrence.tsang
Comment:
Deletions are marked like this. Additions are marked like this.
Line 7: Line 7:
Participants:  Participants:
Line 11: Line 11:
  * 11/2-3: Opening the chambers (top and cross tube), Fixing the IP and filters, Disconnection of the cables. 11/4: Disconnection of the cryo-payload.
 * MN oplev table design
 * design of new small hexagon(Cable bandling bellow BF)[[attachment:Assy small hexagon for BF-CRYO.pdf]]
Line 15: Line 18:
Participants:  Participants:
Line 20: Line 23:
 * Clean-up of the IXV and IYV area.
Line 21: Line 26:
 * Clean-up of the BS and SR area.
 * Hirata-san asked for a quotation for 3 Top Filter keystone plates (for BS, SR3 and SR3 in case it's needed).
 * Fabian made progress in writing a document about LVDT card recovery. One more working day is needed.
 * We lost Hirose-san's lamps for checking cleanliness of mirrors. We'll keep looking for them.
 * We lost the medium capacity scale we used for ballast mass measurement. We need to buy one. I borrowed Miyoki-san's for a few days but he wants it back.
Line 25: Line 36:
Line 32: Line 42:
  * Turn-off for the power outage. Type-A/C: Takahashi, Type-B: Fabian, Type-Bp: Miyo
Line 46: Line 57:
[Terrence]
Very short introduction to VISHack
[[https://gwdoc.icrr.u-tokyo.ac.jp/cgi-bin/private/DocDB/ShowDocument?docid=12125 | Slides]]

Agenda/Minutes on 2020/10/9

Zoom Meeting

CRY+VIS Interface Meeting

13:30-

Participants:

  • Post O3 Upgrade portal

  • Schedule on ETMY.
    • 11/2-3: Opening the chambers (top and cross tube), Fixing the IP and filters, Disconnection of the cables. 11/4: Disconnection of the cryo-payload.
  • MN oplev table design

  • design of new small hexagon(Cable bandling bellow BF)Assy small hexagon for BF-CRYO.pdf

VIS Meeting

14:00-

Participants:

Progress report

General

Type-A

  • Clean-up of the IXV and IYV area.

Type-B

  • Clean-up of the BS and SR area.
  • Hirata-san asked for a quotation for 3 Top Filter keystone plates (for BS, SR3 and SR3 in case it's needed).
  • Fabian made progress in writing a document about LVDT card recovery. One more working day is needed.
  • We lost Hirose-san's lamps for checking cleanliness of mirrors. We'll keep looking for them.
  • We lost the medium capacity scale we used for ballast mass measurement. We need to buy one. I borrowed Miyoki-san's for a few days but he wants it back.

Type-Bp

Type-C

Controls

Electronics

Towards O4

Safety

Discussion

[Terrence] Very short introduction to VISHack Slides

Travel Plans

The week from 10/12

  • Takahashi: 10/12-16
  • Sato: 10/12-16
  • Hirata: 10/12-16

The week from 10/19

  • Takahashi: 10/19-10/23

Next meeting

  • On 2020/10/16(Fri)

KAGRA/Subgroups/VIS/VISMinutes20201009 (last edited 2020-10-09 15:41:33 by RyutaroTakahashi)