Differences between revisions 3 and 4

20180313

Today's activities

Workers: Furuta, Hayakawa, Morita, Awai, Yokogawa, Sugimoto, Akutsu and many helps.

Accepted a BRT and two fixed stages at the entrance of Shin-Atotsu.
Brought the BRT and a fixed stage to Yend via Mozumi entrance; left one stage in the center area.
- Lesson: need to put some small suspensions into the delivery box in advance...
- One stage will be delivered to Xend in April after the cryopayload will be rolled into the EXC chamber.
In case, left the stuffs for a day to avoid bedewing.

Thanks to Awai-san, Sawada-san, Miyoki-san, the EYT booth got lights!
Thanks to Kimura-san, the top lid of EYT was already opened! And the side flange was almost opened.
Thanks to Mirapro, the chain block got an shade.

Open both of the side flanges; 養生もすること。
Measure the tilts of the base plate in EYT in several directions
Locate the stage on the base plate within XXX tilts.
Measure the height with a laser leveler?
Locate the BRT on the stage base on XXX as references.
Make GPT on the optical table
Make a model to drive signals from the TMS
Check the response of the TMS by swinging BS, PR2, PR3... etc... with commissioning people
Endのend用のフランジとりつけ。たぶん最後のほうで。
そこのフランジにとりつける透過光用ビューポート。まだ柏にあるはず。
外側の光学定盤の上の取り回しを考えよ。

KAGRA/subgroup/AOS/TMSY1/2018-03-13 (last edited 2018-03-13 23:55:34 by TomotadaAkutsu)

-  ⇤ ← Revision 3 as of 2018-03-13 23:52:47 → 
  Size: 1572
  Editor: TomotadaAkutsu
  Comment:
+   ← Revision 4 as of 2018-03-13 23:55:34 → ⇥
  Size: 1870
  Editor: TomotadaAkutsu
  Comment:
-Deletions are marked like this.
+Additions are marked like this.
 Line 18:
+ * Open both of the side flanges; 養生もすること。
-Line 25:
+Line 26:
- *
+ * Endのend用のフランジとりつけ。たぶん最後のほうで。
 * そこのフランジにとりつける透過光用ビューポート。まだ柏にあるはず。
 * 外側の光学定盤の上の取り回しを考えよ。