Wide Angle Baffle at IYC
|
|
|
|
|||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
||
| << < 2021 / 3 > >> | ||||||
|---|---|---|---|---|---|---|
| Mon | Tue | Wed | Thu | Fri | Sat | Sun |
| 1 | 2 | 3 | 4 | 5 | 6 | 7 |
| 8 | 9 | 10 | 11 | 12 | 13 | 14 |
| 15 | 16 | 17 | 18 | 19 | 20 | 21 |
| 22 | 23 | 24 | 25 | 26 | 27 | 28 |
| 29 | 30 | 31 | ||||
Links to knowledge
Calculations regarding the back-scattering of different Wide Angle Baffle designs (Zeidler)
Personal calc of WAB's stray light noise by Akutsu; due to several uncertain parameters there are several results and no one would know the actual effect!
Heat links positions (by Obuchi) fmkopgehpapgdkcc.png
Task list
Note: some of the tasks can be done in parallel.
Place/install the WAB suspension
Align the position of WAB -> take WAB back to nominal position, put off protectors)
horizontal alignment
yaw alignment
Move it to the saving mode.
Back to the nominal position.
Attach heat links
4 soft heat links to WAB
1 heat link btwn the top and the structure
Attach 2 thermometers
- Set revised blocks under the base plate.
Pin Assignment
P23, to be connected to Cryocon#7 E and F in this order respectively.
Pin Name |
Resistance |
Equipment |
Assign |
Comment1 |
Comment2 |
Connection |
A |
75 ohm |
Thermometer S/N#2564 |
V- |
Green |
WAB |
|
B |
75 ohm |
Thermometer S/N#2564 |
V+ |
Black |
WAB |
|
C |
4 ohm |
Thermometer S/N#2564 |
I- |
Red |
WAB |
|
D |
4 ohm |
Thermometer S/N#2564 |
I+ |
Yellow |
WAB |
|
E |
75 ohm |
Thermometer S/N#360 |
V- |
Green |
Structure |
|
F |
75 ohm |
Thermometer S/N#360 |
V+ |
Black |
Structure |
|
G |
4 ohm |
Thermometer S/N#360 |
I- |
Red |
Structure |
|
H |
4 ohm |
Thermometer S/N#360 |
I+ |
Yellow |
Structure |
|
Note that the pin arrangement (or the naming) is mirrored compared with that of in IXC! Rather, I guess this IXC's would be correct.