Differences between revisions 2 and 6 (spanning 4 versions)

Wide Angle Baffle at IYC

Links to knowledge

Note: some of the tasks can be done in parallel.

Place/install the WAB suspension
Align the position of WAB -> take WAB back to nominal position, put off protectors)
- horizontal alignment
- yaw alignment
Move it to the saving mode.
Back to the nominal position.
Attach heat links
- 4 soft heat links to WAB
- 1 heat link btwn the top and the structure
Attach 2 thermometers
Set revised blocks under the base plate.

P23, to be connected to Cryocon#7 E and F in this order respectively.

Note that the pin arrangement (or the naming) is mirrored compared with that of in IXC! Rather, I guess this IXC's would be correct.

KAGRA/subgroup/AOS/WideAngleBaffleIY (last edited 2021-03-03 18:14:28 by TomotadaAkutsu)

-  ⇤ ← Revision 2 as of 2019-01-09 20:28:47 → 
  Size: 2537
  Editor: TomotadaAkutsu
  Comment:
+   ← Revision 6 as of 2021-03-03 18:14:28 → ⇥
  Size: 2743
  Editor: TomotadaAkutsu
  Comment:
-Deletions are marked like this.
+Additions are marked like this.
 Line 4:
+||<<MonthCalendar(,2021,3)>>|
-Line 34:
+Line 35:
-P23
+P23, to be connected to Cryocon#7 E and F in this order respectively.
-Line 36:
+Line 37:
-||A||75 ohm|| Thermometer || V- || Green ||  ||  ||
||B||75 ohm|| Thermometer || V+ || Black ||  ||   ||
||C||4 ohm|| Thermometer || I- || Red ||  ||  ||
||D||4 ohm|| Thermometer || I+ || Yellow ||  ||  ||
||E||75 ohm|| Thermometer || V- || Green || ||  ||
||F||75 ohm|| Thermometer || V+ || Black ||  ||  ||
||G||4 ohm|| Thermometer || I- || Red ||  ||  ||
||H||4 ohm|| Thermometer || I+ || Yellow ||  ||  ||
+||A||75 ohm|| Thermometer S/N#2564|| V- || Green || WAB ||  ||
||B||75 ohm|| Thermometer S/N#2564|| V+ || Black || WAB ||   ||
||C||4 ohm|| Thermometer S/N#2564|| I- || Red || WAB ||  ||
||D||4 ohm|| Thermometer S/N#2564|| I+ || Yellow || WAB ||  ||
||E||75 ohm|| Thermometer S/N#360|| V- || Green || Structure ||  ||
||F||75 ohm|| Thermometer S/N#360|| V+ || Black || Structure ||  ||
||G||4 ohm|| Thermometer S/N#360|| I- || Red || Structure ||  ||
||H||4 ohm|| Thermometer S/N#360|| I+ || Yellow || Structure ||  ||