Differences between revisions 4 and 6 (spanning 2 versions)

Wide Angle Baffle at IYC

Links to knowledge

Note: some of the tasks can be done in parallel.

Place/install the WAB suspension
Align the position of WAB -> take WAB back to nominal position, put off protectors)
- horizontal alignment
- yaw alignment
Move it to the saving mode.
Back to the nominal position.
Attach heat links
- 4 soft heat links to WAB
- 1 heat link btwn the top and the structure
Attach 2 thermometers
Set revised blocks under the base plate.

P23, to be connected to Cryocon#7 E and F in this order respectively.

Note that the pin arrangement (or the naming) is mirrored compared with that of in IXC! Rather, I guess this IXC's would be correct.

KAGRA/subgroup/AOS/WideAngleBaffleIY (last edited 2021-03-03 18:14:28 by TomotadaAkutsu)

-  ⇤ ← Revision 4 as of 2019-01-09 20:44:32 → 
  Size: 2646
  Editor: TomotadaAkutsu
  Comment:
+   ← Revision 6 as of 2021-03-03 18:14:28 → ⇥
  Size: 2743
  Editor: TomotadaAkutsu
  Comment:
-Deletions are marked like this.
+Additions are marked like this.
 Line 4:
+||<<MonthCalendar(,2021,3)>>|
-Line 34:
+Line 35:
-P23
+P23, to be connected to Cryocon#7 E and F in this order respectively.