Wide Angle Baffle at IYC
|
|
|
|
|||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
Links to knowledge
Calculations regarding the back-scattering of different Wide Angle Baffle designs (Zeidler)
Personal calc of WAB's stray light noise by Akutsu; due to several uncertain parameters there are several results and no one would know the actual effect!
Heat links positions (by Obuchi) fmkopgehpapgdkcc.png
Task list
Note: some of the tasks can be done in parallel.
Place/install the WAB suspension
Align the position of WAB -> take WAB back to nominal position, put off protectors)
horizontal alignment
yaw alignment
Move it to the saving mode.
Back to the nominal position.
Attach heat links
4 soft heat links to WAB
1 heat link btwn the top and the structure
Attach 2 thermometers
- Set revised blocks under the base plate.
Pin Assignment
P23
Pin Name |
Resistance |
Equipment |
Assign |
Comment1 |
Comment2 |
Connection |
A |
75 ohm |
Thermometer |
V- |
Green |
|
|
B |
75 ohm |
Thermometer |
V+ |
Black |
|
|
C |
4 ohm |
Thermometer |
I- |
Red |
|
|
D |
4 ohm |
Thermometer |
I+ |
Yellow |
|
|
E |
75 ohm |
Thermometer |
V- |
Green |
|
|
F |
75 ohm |
Thermometer |
V+ |
Black |
|
|
G |
4 ohm |
Thermometer |
I- |
Red |
|
|
H |
4 ohm |
Thermometer |
I+ |
Yellow |
|
|
Note that the pin arrangement (or the naming) is mirrored compared with that of in IXC! Rather, I guess this IXC's would be correct.