Differences between revisions 1 and 3 (spanning 2 versions)
⇤ ← Revision 1 as of 2016-04-17 04:59:17 →
Size: 30
Editor: YoichiAso
Comment:
← Revision 3 as of 2016-04-18 14:29:56 → ⇥
Size: 915
Editor: YoichiAso
Comment:
Deletions are marked like this. Additions are marked like this.
Line 2: Line 2:
2016/4/18 14:00 - 15:00

Participants: Miyakawa, Aso, Nakano, Ando, Arai, H. Yamaoto, Michimura

1. What to do just after the iKAGRA test run.

 * Save and note all the interferometer settings, configurations to write a paper
 * Calibration confirmation, actuator efficiency measurement
 * Schnupp asymmetryを測れるか??
 * クリーンブースのフィルターを止めてみる
 * FFTアナライザーで干渉計感度を取ってみる。高周波まで。
 * Measure the accurate position of the mirrors (PR3 and BS) with respect to the markings on the floor.
 * oplev stability, noise measurements (with mirror fixed)
 * scattering noise investigation
 * measure PR3 suspension Q values

2. Planning towards bKAGRA

[[http://gwwiki.icrr.u-tokyo.ac.jp/JGWwiki/KAGRA/Subgroups/MIF/TaskList|ISC Task List]]

3. Status of the simulation for the ITM spec.

ISC Meeting on 2016/4/18

2016/4/18 14:00 - 15:00

Participants: Miyakawa, Aso, Nakano, Ando, Arai, H. Yamaoto, Michimura

1. What to do just after the iKAGRA test run.

  • Save and note all the interferometer settings, configurations to write a paper
  • Calibration confirmation, actuator efficiency measurement
  • Schnupp asymmetryを測れるか??
  • クリーンブースのフィルターを止めてみる
  • FFTアナライザーで干渉計感度を取ってみる。高周波まで。
  • Measure the accurate position of the mirrors (PR3 and BS) with respect to the markings on the floor.
  • oplev stability, noise measurements (with mirror fixed)
  • scattering noise investigation
  • measure PR3 suspension Q values

2. Planning towards bKAGRA

ISC Task List

3. Status of the simulation for the ITM spec.

KAGRA/subgroup/ifo/MIF/Minutes20160418 (last edited 2016-04-25 10:10:50 by YoichiAso)