Agenda/Minutes on 2021/2/12

CRY+VIS Interface Meeting

13:30-13:55

Schedule for IX: Release is scheduled on 2/18.
Schedule for IY: Disconnection is scheduled on 3/11.
Schedule for EX: Connection is scheduled in the week of 3/15.
Corrugate tube fixing jig: Re-measurement is planed in 2/26-3/1 at IYV.
Commissioning in air: Commissioning of IX will be started. Other schedule has not been decided yet.
Commissioning in vacuum: Closing of DN800 flange is available within a half of day.
Acceptance check: Cryo-payload in IX and Type-A tower in EY are on going.
PF actuator: Not evaluated in IX, but after the commissioning for suspension.
Jig for FC painting: Delivered.

14:00-15:30

Participants:

From: 2021-02-12 00:00:00

EY
15993 Setup of F2 , ryutaro.takahashi
- 15997 Comment, ryutaro.takahashi
- EY
16023 Comment , ryutaro.takahashi
- EY
16034 Comment , ryutaro.takahashi
General
15737 We investigated the network connection. , satoru.ikeda
- 16028 Comment, satoru.ikeda
General
16038 Initialize the OSEMINF filters for all Type-Bp suspensions , kouseki.miyo
- 16040 Comment, kouseki.miyo
General
16036 Cabling for temperature control equipment , satoru.ikeda
General
16038 Initialize the OSEMINF filters for all Type-Bp suspensions , kouseki.miyo
MCF
16041 Recovery of IMC suspension , ryutaro.takahashi
PR3
15889 Traverser motor test and cabling. , fabian.arellano
- 16001 Comment, satoru.ikeda
- PR3
16027 Comment , satoru.ikeda
PR3
15976 Picomotor of PR3_BF_T(Motor2) got stuck , satoru.ikeda
- 16000 Comment, satoru.ikeda
- PR3
16024 Comment , fabian.arellano
- PR3
16026 Comment , satoru.ikeda
- PR3
16032 Comment , fabian.arellano
PRM
9449 PRM glitch investigation: , koki.okutomi
- 15995 Comment, shinji.miyoki
SR3
15963 IM ballast mass adjustment , fabian.arellano
- 16009 Comment, fabian.arellano
SR3
16007 Ballast mass adjustment on top of BF , fabian.arellano
- 16018 Comment, fabian.arellano
- SR3
16035 Comment , fabian.arellano
SR3
16007 Ballast mass adjustment on top of BF , fabian.arellano