1741
Comment:
|
1765
|
Deletions are marked like this. | Additions are marked like this. |
Line 22: | Line 22: |
* Align the position of WAB -> take WAB back to nominal position, put off protectors | * --(Align the position of WAB -> take WAB back to nominal position, put off protectors)-- |
Line 24: | Line 24: |
* yaw alignment * Lift-up WAB by 2mm * Blow inside the WAB; put protectors and shield the aperture (foil?) |
* --(yaw alignment)-- * --(Lift-up WAB by 1mm)-- * --(Blow inside the WAB; put protectors and shield the aperture (foil?))-- |
Wide Angle Baffle at IXC
|
|
Links to knowledge
Calculations regarding the back-scattering of different Wide Angle Baffle designs (Zeidler)
Personal calc of WAB's stray light noise by Akutsu; due to several uncertain parameters there are several results and no one would know the actual effect!
Heat links positions (by Obuchi) fmkopgehpapgdkcc.png
Task list
Note: some of the tasks can be done in parallel.
Place/install the WAB suspension
Align the position of WAB -> take WAB back to nominal position, put off protectors
horizontal alignment
yaw alignment
Lift-up WAB by 1mm
Blow inside the WAB; put protectors and shield the aperture (foil?)
- Clean area around chamber
Heat-Link adapter to WAB -> Needs to be designed (Akutsu/Obuchi)
- Thermometer adapter to WAB